Completely remove the hotspot entry from wifi settings,then add it back and look to statically assign the IP address in advanced settings when entering the password, this may not work on all devices and once the gateway changes this may be an issue with static assignment, you could look to use an app called fing to find hosts on the network or you could look to manipulate the hosts file each Worse, in Android 12, in Developer options, you can set a switch to randomize the Wi-Fi radio MAC address of the phone on every connection, regardless of the SSID. Hence, you have to set the "static" IP address request in the phone itself, so that the router will respect that request for a static IP address. So, in order to change its IP address, or anything actually, you must be able to access the initial IP address in the first place. In the case of this product, it doesn't rely on DHCP and its dynamic nature, but in a static IP in the 192.168.43.0 range, because when a Hotspot with an specific SSID is created, the device connects to it an can be Because: src-address is matching criteria which tells NAT engine which packets it should affect and in your case it should affect packets send by PC. At the same time it's good to narrow down the matching to packets with destination IP of IoT device (in your particular use case it wouldn't matter much, but if there was internet access involved, then this NAT rule would mess traffic towards First, if your devices had static IP addresses from your previous internet gateway/router, it is highly likely that it was using a different subnet than TMO gateway/router. Unfortunately, there is no feature in the TMO gateway/router where you can change the subnet address. If this is the case for you, then you could try adding a separate Change hotspot subnet address. The WiFi hotspot offer the WiFi clients IP settings within a certain IP subnet (see lower part of graphics): The default values for these subnet settings are: IP address of WiFi hotspot: 192.168.42.1; Subnet mask: 255.255.255.0; DHCP range: 192.168.42.10.. 192.168.42.250; If these settings shall be changed, the There is a strong cell signal so the thought it a cell based hotspot that casts WiFi tot he store. That needs a static IP though for the POS system. Gotcha. Yes there are 4g hotspots that can do this. I can't recommend any though, because the mods here are inanely strict about banning you for that. Password: Guests must enter a password to connect. Payment: Guests must pay to use the WiFi. This is currently supported by Stripe. Vouchers: Provide guests with vouchers that can be used to authenticate. Customize vouchers to support various expiration times, bandwidth limits, or data consumption quotas. RADIUS (advanced): Preconfigure guest Refer to the Hotspot WebUI Manager or the Quick Start Guide if you need to change your hotspot Wi-Fi Network Name (SSID) or Wi-Fi Password. USB tethering To connect your Wi-Fi enabled device to the mobile hotspot using a USB-C cable instead of using the Wi-Fi network follow these steps. 2i6X1.

how to change hotspot ip address